







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterHow Much Does Backsplash Installation Cost in Kendale Lakes?
Backsplash installation in Kendale Lakes typically costs $800 to $2,500 for a full kitchen wall, including tile, setting materials, and labor. A small galley kitchen or a simple 4-inch splash runs near the low end, while a floor-to-ceiling tile wall behind a range or a large-format slab lands at the top of that range. Every job here is priced by a written estimate, so the number you get in writing is the number that holds.

Backsplash Installation Cost Breakdown (2026)
Here’s how the typical estimated ranges break down by scope. These are 2026 figures for the Kendale Lakes market, not exact quotes. Your written estimate sets the final price.
| Scope of Work | Typical Estimated Cost |
|---|---|
| 4-inch short splash (standard counter height) | $800 – $1,100 |
| Standard 18-inch splash behind counters, ceramic or porcelain | $1,100 – $1,700 |
| Full-height splash behind range or cooktop, tile | $1,500 – $2,200 |
| Full wall floor-to-ceiling tile, mid-size kitchen | $1,900 – $2,500 |
| Large-format slab or engineered stone panel, per wall | Top of the $800 – $2,500 range |
What moves a backsplash estimate up or down? Square footage is the obvious one, but it’s rarely the biggest factor. Tile choice matters more. A basic porcelain subway tile might cost a fraction of a hand-glazed zellige or a bookmatched marble. Pattern complexity drives labor: a straight stack installs quickly, while herringbone, chevron, or a mosaic with a border cuts the pace and the cost climbs. The condition of the wall behind the old splash matters too. In Kendale Lakes, plenty of kitchens sit behind drywall that’s been softened by years of humidity, and a worn substrate means cement board, waterproofing, and more labor before a single tile goes up. Cutting around outlets, windows, and a range hood adds detail time. And if the countertop is being replaced in the same project, the equation changes because the splash can go in as part of the same scope.
What Affects Backsplash Installation Pricing in Kendale Lakes
Every kitchen we walk into has its own set of variables. Here’s what actually shapes the number on a Kendale Lakes backsplash estimate.
- Wall square footage and height. A 4-inch splash is a small job. A full wall floor-to-ceiling behind the range can be three or four times the tile and labor. We measure the actual wall area, not the countertop length, because that’s what determines material and time.
- Tile material and format. Ceramic and porcelain are the workhorses and stay budget-friendly. Natural stone, marble, and engineered stone slabs cost more per square foot and demand more careful setting. We work with engineered stone and surfacing brands like Cambria, Silestone, and Caesarstone, and we can line up options at several price points so you’re not stuck with one spec.
- Pattern and layout. A straight stack or a simple running bond is efficient. Herringbone, chevron, basketweave, and mixed mosaic need more cuts, more layout time, and more waste. That labor difference is real.
- Wall condition and substrate prep. Removing an old backsplash almost always takes some drywall with it. The wall behind needs to be flat, dry, and properly prepped with cement board or a waterproof membrane. In this climate, moisture behind a counter is common, so prep isn’t optional.
- Cutouts and detail work. Every outlet, switch, window edge, and range hood requires precise cuts. A kitchen with a dozen outlets and a window over the sink is a different job than a flat wall over a single counter run.
- Access and staging. A kitchen on the second floor or down a long hallway takes more time to protect floors, move materials, and keep dust contained. We budget for that rather than surprise you later.
Kendale Lakes sits in a warm, humid part of South Florida, and that shapes the work. Kitchens here often have exterior walls, which means the backsplash sits against a wall that sees temperature swings and moisture. We use waterproofing behind tile in those spots so the tile stays put and the grout doesn’t get a foothold for mildew. It’s not glamorous, but it’s what keeps a splash looking sharp instead of showing mold streaks within a year.

How to Save on Backsplash Installation
You don’t have to sacrifice quality to keep a backsplash within a sensible budget. A few decisions make the biggest difference.
- Choose tile with a bit of restraint. Porcelain and ceramic in a classic shape cost a fraction of specialty stone and still give you a clean, durable surface. The labor is simpler too.
- Pick a simpler layout. A straight stack or running bond keeps cut waste low and install time down. If you love herringbone, consider it on a smaller accent wall behind the range rather than the entire splash.
- Limit full-height walls. A full splash to the upper cabinets is budget-friendly. Taking tile all the way to the ceiling over a range is where the cost climbs. Choosing one signature full-height spot often looks better than covering every wall.
- Bundle the work. If you’re also replacing countertops or cabinets, a backsplash done in the same scope saves on setup, demolition, and prep. We handle countertop installation and cabinet installation as part of the same project so the splash goes in as the final step of a coordinated job.
- Don’t skip prep. Cutting corners on waterproofing behind a backsplash can cost far more later. Getting it right the first time is the cheaper path.
The most reliable way to save is a free estimate that lays out the scope line by line, so you can decide where to spend and where to simplify. Call (866) 531-4751 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Repair or Replace: What Makes Sense for Your Backsplash?
If the grout is cracking but the tile is sound, repair is often the cheaper route. If the tile is dated, loose, or the wall behind it is compromised by moisture, replacement is usually the smarter long-term call. A single popped or cracked tile can be swapped, but shrinkage and humidity in a Kendale Lakes kitchen often cause a patch-and-repair cycle that ends up costing more than a fresh install. We look at whether the substrate is holding up before recommending a patch, because no repair lasts long on a failing wall.
Backsplash as Part of a Larger Kitchen Remodel
A backsplash rarely lives alone. It’s the last finish that ties cabinets, counters, and lighting together. If you’re planning a larger update, it helps to think about the whole scope at once. A kitchen remodel in this market typically runs $14,000 to $45,000 depending on size and finishes, and a backsplash is a small slice of that. A small kitchen remodel lands more in the $9,000 to $20,000 range, and a kitchen island installation can run $3,000 to $10,000. Planning the splash alongside those projects means the tile lines up with the cabinet reveal and the outlets land in the right spots the first time. One contractor from the roof to the driveway means the electrician, the counter guys, and the tile setter are working from the same plan. We specify the right material for the job, then stand behind it.
What’s Included in a Backsplash Installation Estimate?
A clear scope is everything. Here’s what a professional Kendale Lakes backsplash installation should cover:
- Removal and disposal of the existing splash or drywall
- Wall inspection and repair, including cement board or backer as needed
- Waterproofing or membrane in wet-prone areas
- Layout and measuring for even cuts and clean edges
- Tile setting, grouting, caulking, and cleanup
- Sealing for natural stone (and any porous tile)
What’s not automatically included: outlet relocation, under-cabinet lighting changes, range hood removal, or new countertops. Those are separate scopes and should be spelled out. We put it all in the written estimate so there’s no gray zone on install day.
FAQs – Backsplash Installation Cost
How much does backsplash installation cost in Kendale Lakes?
Backsplash installation in Kendale Lakes typically runs $800 to $2,500, with most full-wall jobs landing in the $1,500 to $2,200 range. The final number depends on square footage, tile choice, layout, and what’s happening behind the old splash. Call (866) 531-4751 for an exact quote – estimates are free.
Is it cheaper to repair or replace a backsplash?
Repair is cheaper when the tile and wall behind it are sound – a regrout or a few replacement tiles usually fits in the low end of the $800 to $2,500 range. If the wall is soft or the tile is loose, replacement is the better value because patchwork over a failing substrate doesn’t last. We’ll tell you honestly which one your kitchen needs. Call (866) 531-4751 and we’ll walk through it.
How much does a tiled backsplash cost for a standard kitchen in Kendale Lakes?
A standard 18-inch tiled splash behind counters in Kendale Lakes usually costs $1,100 to $1,700 with ceramic or porcelain tile. Full height behind the range pushes that to $1,500 to $2,200. Specialty stone or a slab panel moves to the top of the $800 to $2,500 range. Call (866) 531-4751 for a free estimate on your wall.
Can you install a backsplash the same day?
Many backsplashes are a one-day install once prep is done, and same-day service is often possible for a straightforward job. Larger walls, slab panels, or wall repairs can add time. We honor fast dispatch from 7am to 7pm, Sunday through Friday, and we answer 24/7 if you need to book. Call (866) 531-4751.
Does a backsplash cost more with a countertop replacement?
Installing a backsplash alongside a countertop replacement often costs less than doing them separately, because the splash goes in as part of the same setup and prep. A countertop installation typically runs $2,000 to $6,500, and the splash is added to that scope at a better rate than a standalone job. Call (866) 531-4751 for a combined estimate.
Why Choose Kendale Lakes Construction for Backsplash Installation?
Kendale Lakes Construction is a full-service residential construction company handling seven core service lines, from kitchen and bath remodeling to roofing, windows, hardscape, fencing, and additions. That matters for a backsplash because the finish depends on everything underneath it: the wall, the counter, the cabinets, the electrical. One point of contact from permit to punch list removes the finger-pointing that happens when three trades blame each other. Our technicians have up to 10 years of experience, and we work from a curated roster of 50+ manufacturer brands so you get real choices, not a take-it-or-leave-it spec. We can remodel a bathroom, replace windows and doors, install a new roof, build a home addition or ADU, lay driveway pavers, or set a fence – and coordinate it all under one contract. Real brands, real choices, and a scope that’s clear from the start.
Whether you’re refreshing one wall or reworking the whole kitchen, tell us your project and we’ll build the roadmap. Call Kendale Lakes Construction at (866) 531-4751 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. Same-day service is available on many backsplash jobs. Your written estimate sets the final price, and there’s no fee for it.
Pricing reflects the Kendale Lakes market as of 2026. Kendale Lakes Construction offers free estimates – call (866) 531-4751.
What Our Customers Say
"The framing was meticulous and the walls are straight everywhere. Drywall goes on a lot better when the framing is right."
- Luis Mendoza"Weekly site meeting, every week, with a written summary afterward. I always knew where the money and the schedule stood."
- Danika Jackson"Excellent build. Costs came in about six percent over the original contract, driven mostly by material price movement during the build, which he documented each time."
- Terrence Ingram












